Header Ads

CONVERSION FOR SWIPE ELITE PLUS - 2016 EDITION

How to convert swipe elite plus


ABOUT:

This conversion is very crucial to install a custom rom on your swipe elite without it your phone can be permanently bricked.

PROCEDURE:

Step 1:

Restore the QCN from this Link: Link (For network coverages)

Step 2:

Connect your phone to PC in switch off mode

Hold down VOLUME UP+VOLUME DOWN+POWER

Voila you are in download mode

step 3:

Install proper adb driver for this phone
To check out this Right click on My computer>Device Manager>On the port you can see the qualcomm.

if you can see then install adb drivers properly for your phone

Step 4:

Download and Install the flash tool from here

Step 5:

After Completing intallation BACKUP your QCN file

Stat>All Programs>QPST>QFIL

then select TOOLS>QCN BACKUP RESTORE then backup your QCN. 

IF YOU CAN'T BACKUP YOUR QCN DON'T WORRY JUST DOWNLOAD IT FROM HERE

Step 6:

OpenMenu->QPST->QFIL

Phone power off, remove USB cable, hold volume buttons(both“+”and“-”),

Insert thedata cable and release the buttons after the red interface pops up;

Hold volumebutton (+) again until the mobile phone’s screen turn black

Release thevolume button again; the phone is already in downloading mode.

Port 9008will appear in the QFIL, if can not be identify 9008, pls click “select port”

Step 6:

Start to flash phone:

1.   ChooseFlat Build inSelect build type

2.   ClickBrowse, and choose “prog_emmc_firehose_8936.mbn” , then click search patch

3.   Click Load XML, and choose “rawprogram0_unsparse.xml” , and continue to choose  “rawprogram0.xml”

4.   Click“Download”to start

Step 7:

Restore your QCN

After flash, need to use QFIL to restoreQCN,

Open menu->tools->QCNbackup restore

ClickBrowse and select the file you backup one, then restore

Step 8:

After download complete HOLD your POWER BUTTON (10sec)

when the phone is powered a small linux logo appear.. then you all done! 

NOW YOUR DEVICE IS CONVERTED TO TCL M3G.

Step 9:

After Setup Complete SWITCH OFF the phone.
hold down VOLUME UP+POWER BUTTON to enter recovery
Then select Go to BOOT LOADER
Now Download This two Files

                               

After downloading these files
Extract ADB Drivers then put twrp.img into that folder

Open command window then copy and paste the command "fastboot flash recovery twrp_en.img"
after completion turn on the device by holding the power button 

Congratulations

your device is converted with TWRP RECOVERY





1 comment:

Powered by Blogger.